Gas Engineer Callouts in Stratton St Margaret

You can keep it if it checks out, or replace it, usually alongside a new boiler. Because a back boiler runs the heating and hot water, removing it means installing a new heat source at the same time. I'll talk through what would suit the house.

No, it is usually a small job. The cooker is pulled out, the old hose is disconnected and a new one fitted to suit the cooker, then the connection is tested for tightness and the stability bracket checked. If the hose looks damaged, stop using the cooker until then.

Yes, in most cases, as long as the boxing can be removed for access and joints are not sealed away permanently. Gas pipe should not be buried where it can be damaged. If you are planning boxing as part of a refit, ask me first.

Tell me what gas appliances are in the property and I will say what I can help with. Include the address and a list of the gas appliances in the house, so the conversation starts with the right information.

It may be. Sometimes the old supply was capped properly and sometimes it was simply turned off nearby. It is worth having a competent gas engineer confirm what is behind the fireplace and that any old supply is capped correctly. Tell me what you can see and I'll talk you through what's involved.

Yes. Stratton St Margaret is about 4 miles from Highworth and within the area I cover, along with nearby Swindon, Blunsdon and Old Town. Include your postcode in the enquiry and I'll confirm.

A photo of the fire and the fireplace around it, whether there is a back boiler behind it, and what you plan to put there instead. Your postcode helps too. That tells me whether it is a simple capping job or something bigger involving the heating.

It can, but the cooker manufacturer sets side clearances, and some fridge makers also advise against placing them right next to a heat source. Check both sets of instructions, or send me the model numbers and I'll talk them through before the kitchen layout is fixed.

Usually. The supply has to be extended or rerouted to the new position, ideally before new flooring or units go in. The pipe size needs to suit the extra length and whatever else it feeds, and the cooker should be tested once connected in its new spot.

Generally, yes. An accessible isolation valve on the hob supply lets the hob be disconnected or serviced without turning off gas to the whole house. One is usually best fitted when the hob is installed or replaced, somewhere it can be reached afterwards.