Gas Engineer Services in Chiseldon

Yes. Chiseldon is about 8 miles from Highworth, and with the village close to Junction 15 of the M4 it is a straightforward drive. It is one of the 13 towns and villages I cover, alongside nearby Coate and Wroughton.

A built-in hob is usually hard-piped with a fixed connection, while a freestanding cooker normally uses a flexible hose and a stability bracket. The hob also needs the right worktop cut-out and clearances. Each is tested for tightness once connected.

It is better not to. Over time a chimney can collect debris or nests, and parts in the fire can deteriorate. The flue, the ventilation and the fire itself should be looked at before it is used again. Tell me about the fire and I'll talk you through what's involved.

Normally the hob or cooker is disconnected and the supply temporarily capped, so the kitchen fitters can work safely. Once the new units are in, the appliance is reconnected in its new position and the installation tested for tightness. Tell me the fitters' dates and I'll talk you through it.

Symptoms include headaches, dizziness, nausea and tiredness that ease when you leave the house. Signs on appliances include soot, staining or a yellow flame. If you suspect it, turn appliances off, get fresh air, seek medical advice and call the National Gas Emergency Service on 0800 111 999.

The visible parts can be traced and the likely route of the rest worked out, which is useful before a refit or renovation. Some runs are buried in walls or floors, so it matters to be clear about what can be seen and what is an informed estimate. Tell me about the project and I'll talk you through it.

No. If the oven doesn't light after a couple of tries, stop, turn it off and let any gas clear. It could be an ignition fault or a safety device, and repeatedly trying can let unburnt gas build up. Get it checked before using it again.

Ask how the appliance works, what was done and whether anything about the installation is worth keeping an eye on. Ask anything you're unsure of, including whether something is worth keeping an eye on, and I'll answer in plain language.

Yes. Any job that disconnects and reconnects a gas supply should be done by a competent gas engineer, even a like-for-like swap. The new connection needs to be made correctly and the installation tested for tightness before the hob is used.

Usually, yes. The meter is a key point on any gas job, so keep the area around it clear. If it is in an outside box that needs a key, or behind stored items, let me know beforehand so it can be cleared.